Philips 44PL9523 Guia de preparacion descargar pdf (Pagina 1)

HDTV Monitor

Quick Use and Setup Guide

3135 035 21291

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT

EXPOSE THIS UNIT TO RAIN OR EXCESSIVE MOISTURE.

As an Energy Star® Partner, Philips Consumer Electronics has deter-

mined this product meets the Energy Star® guidelines for energy effi-

ciency. Energy Star® is a U.S. registered mark. Using products with

the Energy Star® label can save energy. Saving energy reduces air pollution and

lowers utility bills.

3135 035 21301

HDTV Monitor

44PL9523

55PL9523

Refer to the Quick Use and Setup Guide (supplied with your TV)

for information on basic connections, remote control button

descriptions, on-screen menu language, and Autoprogram.

Highlights

• Liquid-crystal-on-silicon (LCOS) High-definition

Imaging

• High-resolution Display—1280 x 720 pixels

Features

• Digital Natural Motion™

• Digital Crystal Clear™

• Active Control™—analyzes and adjusts incoming signal

• Two-tuner, Double-window PIP (Picture-in-Picture)

• Dolby

Virtual Surround, 40-watt RMS

• 3D Y/C Comb Filter

• HD Component and DVI Input

• Center Channel Audio Input

• Side AV Convenience Jacks

• Matching stand and swivel available

4/21/03

See the User Manual for Important Maintenance Information

Keep the Directions for Use manual

accessible to correctly maintain and

care for your TV, as well as to

understand and use its features.

Warning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

See the User Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

Positioning the TV . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2

Mounting the Swivel to the TV . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2

Mounting the Swivel and TV to the Stand . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3

Making Basic Connections to the TV . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3–5

Operating the TV . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5

Using the Remote Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6

Using the On-screen Menu . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

Using the Demo Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

Using the Installation Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8

Contents

In addition to providing information about safety, connecting accessory devices,

and using the TV’s features, the Directions for Use manual explains how to care

for and maintain your Cineos television. The TV contains air filters that must be

maintained and eventually replaced, and a lamp that eventually will need to be

replaced.

Air Filters

The air filters (located at the bottom of the TV) must be kept clean and free of

blockage.

NOTE: DO NOT operate the TV without the filters. Damage to the TV will occur.

Allow four to six inches of space behind the TV for air flow through the back

slots.

IMPORTANT: Excessive heat inside the TV resulting from inadequate ventilation

will cause the TV to shut down or not

to operate.

Lamp

An on-screen message will alert you when the lamp is nearing the end of its

expected lifetime so that you can change it before it wears out.

IMPORTANT: The TV will not operate if the lamp door is left open, and the TV

will shut down if the door is opened during operation.

Picture Settings

Your TV was set up at the factory for optimal showroom viewing. For optimal

home viewing change the Auto Picture setting to Natural. See page 34 in the

Direction for Use Manual.

6/23/03

INT

EXT

DVI

S-VIDEO

RLV

Pr Pb Y

STANDARD/

HD INPUTS

STANDARD/

HD INPUTS

TUNER

RGB+HV

AV5 AV6

AV1MONSUB OUT AV2AV3AV4

OUT

SERVICE 1

EXT

Locations of Air Filters

Ventilation Slots

The lamp door must be closed for the TV to operate.

Lamp Door

Back of TV

IMPORTANT! Initial TV Setup

When you turn on your TV for the first time it will prompt you to enter

some setup information about Language preference and Channel program-

ming. See page 8 in this Quick Use and Setup Guide for more information

about these menus.

Language Autoprogram

Select your menu language with

the cursor up/down.

Press the OK key on the remote

control to confirm.

Please read this Quick Use and Setup Guide completely before

you turn on the TV.

1 2 3 4 5 6 7 8

Indice de contenidos

Pagina 1 - IMPORTANT! Initial TV Setup

HDTV MonitorHDTV MonitorQuick Use and Setup GuideQuick Use and Setup Guide3135 035 21291WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOTEXPOSE THIS UN

Pagina 2 - Mounting the Swivel to the TV

Positioning the TVAllow 4 to 6 inchesbehind the TV forventilation.Place the TV ona flat surface.Do not place the TV on a surface that will blockthe ai

Pagina 3 - Cable TV

3Making Basic Connections to the TVCable TVDVIGS-VIDEOGS-VIDEORLVRLRLRLVPr Pb YRLRLPr Pb YPr Pb YRLVSTANDARD/HD INPUTSSTANDARD/HD INPUTSTUNERRGB+HVAV5

Pagina 4 - Cable Box with A/V Outputs

Making Basic Connections to the TVDVIGS-VIDEOGS-VIDEORLVRLRLRLVPr Pb YRLRLPr Pb YPr Pb YRLVSTANDARD/HD INPUTSSTANDARD/HD INPUTSTUNERRGB+HVAV5 AV6AV1MO

Pagina 5 - Operating the TV

MENUVOLUMECHANNEL243441Remote Sensor WindowReceives commands from the remote control.Making Basic Connections to the TV5Operating the TVActive Control

Pagina 6 - Using the Remote Control

Using the Remote Control6Power–StandbyPress to turn the TV on or off. NOTE: The TV is never poweredoff completely unless it is unplugged.Alternate Aud

Pagina 7 - Using the On-screen Menu

SOUND PICTUREACITVECONTROLZOOM1 2656Picture Sound Features ChannelsTVSettingsDemoInstallPicture Sound Features ChannelsTVSettingsDemoInstall12

Pagina 8 - Language

SOUND PICTUREACITVECONTROLZOOM1 223526417AutoprogramInstall modeInstallStart60 analog channels foundAutoprogramming is completeAutoprogramInstall mode