Philips TS3654C Manual de usuario descargar pdf (Pagina 29)

Using the Remote's VCR Buttons

W

hen using the TV remote

with a VCR, first make cer

tain it is set to control your VCR

(by the REMOTE CODE or

SEARCH method - see earlier

section).

CBEOirfl

Press the VCR System but-

I ton on the remote.

Point the top of the remote

toward the front of the VCR

(remote sensor window) when

pressing buttons.

Record (Clear) Button

Hold the RECORD button down, and

then press the PLAY button to begin

a VCR recording. The CLEAR button

can be pressed to erase incorrect data

when programming VCR functions.

The Clear button can also be pressed

to reset the VCR’s real time counter.

Rewind Button

Press to rewind tapes. For some

VCRs you may need to press STOP

button first then REWIND. In play

back mode hold button down to view

picture moving rapidly in reverse.

Pause Button

Press to temporarily stop the tape

during a playback or recording. Press

again to release Pause.

TV-VCR Button

Press to the VCR position ("VCR"

indicator on the VCR will light) to

view the playback of a tape. Press

again to place in the TV position

("VCR" indicator on the VCR will go

OFF) to view one program while

recording another program.

When used with the TV the TV/VCR

button works as a source button.

Each press cycles the TV between

channels 3 and 4; or the VCR/AUX

Input mode. It is a quick one-button

way to select these channels and

modes (without directly entering the

TV's Menu system.)

o p

VOl

CH

loj

Lq)

(ON/OFFi ros M SWAP ■ FREiZE )

PIP

Play Button

Press to playback a tape. Hold down

after pressing the RECORD button to

start a recording.

Stop Button

Press to stop the tape.

Fast Forward Button

Press to rapidly advance the tape. For

some VCRs you may need to press

STOP first then FF. In Playback

mode hold button down to view the

picture moving rapidly in the forward

direction.

Channel Scan Buttons

Press to scan up or down through

VCR channel numbers.

Number Buttons

Press buttons for direct VCR channel

selections .

VCR System Button

Press to send remote commands to

the VCR.

Power Button

Press to turn the VCR ON and OFF.

Smart Help

Remember, the VCR but-

% tons on the remote will not

operate your VCR if those fea

tures are not already found on

your VCR remote control.

Note: All VCR functions (particu

larly Search, Rewind, Fast

Forward, etc.) will operate the

same as with the original VCR

remote control provided with the

VCR.

29

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Comentarios a estos manuales

Sin comentarios