Philips RFX600099 Manual de usuario descargar pdf

User Guide

Introduction

Note: In this user guide Pronto is used for both ProntoPro and Pronto remote controls.

RFX6000 is compatible with TSU3000 and TSU6000.

About the RFX6000

Most remote control systems have to be operated by pointing the remote control

directly towards a device. Any obstacle between the remote control and the device

disturbs the operating signal. But what if you like to place your devices inside a

closed cabinet, a closet or even in another room?

The RFX6000 provides the solution to overcome obstacles like furniture or walls.

Your devices no longer have to be placed in line of sight but can be operated from

virtually any location. The RFX6000 is a RF Extender that is used in combination

with the Pronto Remote Control. The RF Extender receives radio frequency (RF)

signals sent out by the Pronto and converts them into infrared (IR) signals. These

IR signals are then sent out to your TV, DVD, preamplifier and so on.

Introduction

Pronto RF Extender

RF signals IR signals

RFX6000 new 24-07-2002 14:04 Pagina 1

1 2 3 4 5 6 7 8

Indice de contenidos

Pagina 1 - Introduction

User Guide1IntroductionNote: In this user guide Pronto is used for both ProntoPro and Pronto remote controls.RFX6000 is compatible with TSU3000 and T

Pagina 2

User Guide2IntroductionPossible Set-upsThe RF Extender can be used in several situations:• Your devices can be remotely controlled while the RF Extend

Pagina 3 - Installation

User Guide3InstallationInstallationThe following components should be present: RF Extender, power adapter, 4 dual IR emitters, mounting plate and 4 sc

Pagina 4

User Guide4MountingThe RF Extender can be mounted to a piece of furniture using the includedmounting plate and the 4 screws. Take into account the ran

Pagina 5

User Guide5InstallationHow to use the emittersThe dual IR emitters can be attached to the surrounding surface facing thereceiving eyes or directly to

Pagina 6

User Guide6InstallationSettingsAs the RF Extender ‘communicates’ with the Pronto Remote Control, you have toset the same Extender ID (identity) on bot

Pagina 7 - Troubleshooting

User Guide7TroubleshootingTroubleshootingDevices do not respond properly• Check if the power adapter is connected and the red LED is on.• Check if the

Pagina 8 - Specifications

User Guide8SpecificationsThe specifications and design of this product are subject to change without notice.Hardware Red LED (continuously on when po